The display will show, for example: Part Setting the System using Part 2 or 3. At the start of the setting procedure, a fault Exit Now! Eurosec CP8L User ManualĮxit the premises via an authorised exit route. After checking the premises are secure: Enter a valid User Code followed by. The bottom line of the display will then be blanked off.įull Setting the System. Set or Unset Status will only be displayed for ten seconds when the system is Set or Unset. Throughout this manual, reference will be made to the Master User Code, the factory set default is Display Status Blanking Depending on Control Panel installed, it may be a requirement that the Status Set or Unset display of the security system is not displayed. Several user programmable options are available that will be covered later in this manual. Your installation company will have programmed your system to protect your premises to the highest possible standards. Introduction Welcome to the eurosec control panel. View and Download Eurosec CP8L user manual online. Wire the LCD RKP as shown in the wiring section of this manual.
The eurosec control panel is supplied as a blank fronted end station. Throughout this manual refer- ence will be made to the User Code, the factory set default is This code is programmable along with eight other User Codes.
